Problems/Service/Repairs If you have a problem with your HHR, want a tip on repairing or performing a particular service to you HHR here is the place to post!

Mass Air Flow Sensor problems.....

Old 07-08-2012, 07:28 PM
  #1  
Senior Member
Thread Starter
 
ChevyM84's Avatar
 
Join Date: 01-09-2009
Location: Homestead, Fl
Posts: 273
Angry Mass Air Flow Sensor problems.....

I have an 08 2LT with the 2.4/auto and ive gone through 2 Mass Air Flow sensors. The third time it acted up i took it apart and saw it was dirty and was able to clean it(i know your not supposed to do that but it worked for a good 6months now). Ive been having this problem for the past year(3 times) and now its acting up again. The motor surges and stalls, mostly when at a light but when it gets bad it does it even going 70. Eventualy it throws the MAF CEL and one for random misfire aswell. It doesnt matter if the motor is hot or cold. The only thing i could think of is i put a K&N filter in it about 1 1/2 years ago(ive cleaned it twice since i put it in and re-oiled it) and i wanted to know if anyone else is going through the same thing????
ChevyM84 is offline  
Old 07-08-2012, 08:02 PM
  #2  
Senior Member
 
oneton's Avatar
 
Join Date: 07-13-2006
Location: Geneva, FL.
Posts: 1,567
Don't oil the filter.
oneton is offline  
Old 07-08-2012, 08:19 PM
  #3  
Technical Moderator
 
donbrew's Avatar
 
Join Date: 01-23-2009
Location: Fredericksburg, Virginia
Posts: 24,662
Did you use MAF cleaner (available at your local auto parts store)? It IS the oil from the filter. Yes, almost everyone that installed an oil-able filter has the problem, it seems mostly from over oiling.
donbrew is offline  
Old 07-08-2012, 08:22 PM
  #4  
Senior Member
 
Breadfan's Avatar
 
Join Date: 02-19-2012
Location: Northern California
Posts: 1,015
I'm glad I visited this site before installing a K&N. I was very careful about the amount of oil on the filter and made sure to let it sit for a while before installing.
Breadfan is offline  
Old 07-08-2012, 09:06 PM
  #5  
Senior Member
Thread Starter
 
ChevyM84's Avatar
 
Join Date: 01-09-2009
Location: Homestead, Fl
Posts: 273
no I didn't use the cleaner......but I shall buy a new air filter tomorrow then and clean the airflow meter again......
ChevyM84 is offline  
Old 07-09-2012, 07:12 AM
  #6  
Technical Moderator
 
donbrew's Avatar
 
Join Date: 01-23-2009
Location: Fredericksburg, Virginia
Posts: 24,662
Originally Posted by ChevyM84
no I didn't use the cleaner......but I shall buy a new air filter tomorrow then and clean the airflow meter again......
Be sure to use the MAF cleaner, it is made for the job. Even touching the thing could muck it up, like any fine electrical filament.
donbrew is offline  
Old 07-09-2012, 12:16 PM
  #7  
Senior Member
Thread Starter
 
ChevyM84's Avatar
 
Join Date: 01-09-2009
Location: Homestead, Fl
Posts: 273
yup but that will have to wait cause the HHR was towed to the dealer because the lock cylinder they replaced on saturday stopped working.....
ChevyM84 is offline  
Old 04-28-2015, 01:28 PM
  #8  
New Member
 
aveojoe's Avatar
 
Join Date: 11-15-2010
Location: Ocala
Posts: 11
Maf

we went to an auto parts store the HHR was acting up they said MAF was bad i was wondering if they make an aftermarket MAF?
aveojoe is offline  
Old 04-28-2015, 02:41 PM
  #9  
Platinum Member
 
firemangeorge's Avatar
 
Join Date: 12-06-2009
Location: Alabama
Posts: 11,088
Originally Posted by aveojoe
we went to an auto parts store the HHR was acting up they said MAF was bad i was wondering if they make an aftermarket MAF?
Yes. But the auto parts store you went to should have been able to answer that.

Fwiw. It may not be a MAF problem. If they read the codes and the code # instructed you had a bad MAF, that may be wrong.
Some codes #s can give a "false" positive about which part is defective.
firemangeorge is offline  
Old 04-28-2015, 02:49 PM
  #10  
Technical Moderator
 
donbrew's Avatar
 
Join Date: 01-23-2009
Location: Fredericksburg, Virginia
Posts: 24,662
You can get rebuilt and new MAFs. EBay from China is a lot cheaper.
donbrew is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
artillery0811
Problems/Service/Repairs
14
02-20-2014 05:40 PM
zabadubarbara
Problems/Service/Repairs
19
08-13-2013 12:24 PM
Dieselracer
Problems/Service/Repairs
6
11-17-2010 08:13 PM
Randy08
2.2L Performance Tech
4
07-07-2008 05:05 PM
808jrh
2.4L Performance Tech
4
09-21-2006 05:50 PM


Thread Tools
Search this Thread
Quick Reply: Mass Air Flow Sensor problems.....



All times are GMT -5. The time now is 01:40 PM.